Filament Repair
- Use isopropyl alcohol to clean around the damaged section of the filament.
- Attach tape above and below the damaged section of the filament.
- Using a small brush or marking pen, repair the filament with silver paint or equivalent.
- After approximately 2-3 minutes,
carefully remove the tape without disturbing the repaired area.
- Use a hot air blower heated to 150°C (302°F)
for 30 minutes
or let the paint set for 24 hours
at 25°C (77°F)
to allow it to dry completely.
CAUTION:
- Do not use the rear window defroster until the paint is completely dry. It may cause other malfunctions if it is used before the paint is dry.
Courtesy of MAZDA MOTORS CORP.