After Repair Procedure
CAUTION:
- After repairing a malfunction, perform this procedure to verify that the malfunction has been corrected.
- When this procedure is carried out, be sure to drive the vehicle at lawful speed and pay attention to the other vehicles.
- Connect the WDS or equivalent to the DLC-2.
- Turn the ignition key to ON (engine OFF).
- Verify that DTCs are cleared from memory.
- Decrease ATF temperature to 20 °C {68 °F} or below.
- Start the engine then wait 180 seconds or more.
- Warm up the engine and ATX.
- Engine coolant temperature: 60 °C {140 °F} or above.
- Transaxle fluid temperature: 20 °C {68 °F} or above.
- Shift the selector lever between P position to 1 range (4AT)/M range (Sport AT) while depressing brake pedal.
- Drive the vehicle for 150 seconds or more at a vehicle speed between 25 and 59 km/h {15 and 36 mph}, then 60 km/h {37 mph} or more for 100 seconds or more.
- Drive the vehicle in D range and shift gears between 1st and 4th (TCC operation) gear.
- Gradually slow down and stop the vehicle.
- Make sure that the repaired DTC does not recur.