FixVault
Home › Mazda › 2003 › Protege5 Standard › Repair and Diagnosis › Restraints › Restraints Control Systems › Seat Belt System › Seat Belt Inspection › ELR

Seat Belt Inspection: ELR

  1. Verify that the belt can be pulled out smoothly, and that it moves smoothly when wound.
    • If not as specified, replace the seat belt.
  2. Verify that the retractor locks when the belt is pulled quickly.
    • If not as specified, replace the seat belt.
  3. Remove the retractor. (See FRONT SEAT BELT REMOVAL/INSTALLATION  .) (See REAR SEAT BELT REMOVAL/INSTALLATION  .) (See REAR CENTER SEAT BELT REMOVAL/INSTALLATION  .) 4. Hold the retractor as it would be installed.
  4. Slowly incline the retractor while pulling out the belt.
    Fig 1: Inspecting Seat Belt
    G01914880Courtesy of MAZDA MOTORS CORP.
  5. Verify that the retractor locks at approximately 30°  inclination.
    • If not as specified, replace the seat belt.
    Fig 2: Identifying Retractor Locking Position
    G01914881Courtesy of MAZDA MOTORS CORP.
About FixVault