FixVault
Home › Mazda › 2004 › B3000 SE, Automatic › Repair and Diagnosis › External Pages › Different car › Section 249 (Differential) › Rear Differential Disassembly › Drive Pinion Component Disassembly Note

Drive Pinion Component Disassembly Note

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the removed locknut to the drive pinion top to prevent damage to the thread.
  2. Remove the drive pinion component by tapping the locknut lightly using a plastic hammer.
  3. Remove the locknut installed in Step  1.
Fig 1: Removing Drive Pinion Component
G01345095Courtesy of MAZDA MOTORS CORP.
About FixVault