FixVault
Home › Mazda › 2004 › MPV ES › Repair and Diagnosis (Single Page) › Body & Frame › Exterior Body Panels › Doors And Liftgate › Easy Closure Control Module Removal/Installation

Easy Closure Control Module Removal/Installation

  1. Disconnect negative battery cable.
  2. Remove the sliding door trim.
  3. Remove the screws, and remove the easy closure control module.
  4. Disconnect the easy closure control module connector.
  5. Install in the reverse order of removal.
    Fig 1: Removing/Installing Easy Closure Control Module
    G00997924Courtesy of MAZDA MOTORS CORP.
About FixVault