FixVault
Home › Mazda › 2004 › Tribute DX, FWD › Repair and Diagnosis › Engine Performance › System › Engine Control System › Knock Sensor (KS) - 2.0L ZETEC › Removal & Installation

Removal & Installation

  1. Raise and support the vehicle. Refer to LIFTING .
    NOTE:
    • The knock sensor (KS) is located on the RH side of the cylinder block.
  2. Disconnect the KS electrical connector and remove the connector from the mounting bracket.
    Fig 1: Identifying KS Electrical Connector (2.0L)
    G00984964Courtesy of MAZDA MOTORS CORP.
  3. Remove the nut and the KS.
    Fig 2: Identifying KS Nut (2.0L)
    G00984965Courtesy of MAZDA MOTORS CORP.
  4. To install, reverse the removal procedure.
About FixVault