FixVault
Home › Mazda › 2005 › 3 i, Automatic › Repair and Diagnosis › Engine Performance › Engine Control Systems › Camshaft Position (CMP) Sensor Inspection › Resistance Inspection

Resistance Inspection

  1. Disconnect the CMP sensor connector.
  2. Measure the resistance between CMP sensor connector terminals A and B.
    • If not within the specification, replace the CMP sensor.
    • If the monitor item status/specification (reference) is not within the specification, even though the resistance is within the specification, perform the "CIRCUIT OPEN/SHORT INSPECTION ", and repair or replace the malfunctioning part.

    Resistance 

    1. 400-550 ohms 
About FixVault