FixVault
Home › Mazda › 2005 › 6 i, 4D Hatchback, Standard › Repair and Diagnosis (Single Page) › Engine Performance › Engine Control Systems › Engine Control System (L3) › Camshaft Position (CMP) Sensor Inspection › Resistance Inspection

Resistance Inspection

  1. Disconnect the CMP sensor connector.
  2. Measure the resistance between CMP sensor terminals A and B using an ohmmeter.
    • If not as specified, replace the CMP sensor.
    • If CMP sensor resistance is normal, perform the "Circuit Open/Short Inspection".

      Specification 400-550 ohms 

About FixVault