Inspection of Continuity

NOTE:

Inspect as follows if power steering is inoperative:
- POWER STEERING FLUID INSPECTION (See POWER STEERING FLUID INSPECTION )
Disconnect the PSP switch connector.
Start the engine.
Inspect for continuity between PSP switch terminal and GND using an ohmmeter.
- If not as specified, replace the PSP switch.
- If PSP switch is okay but PID value is out of specification, perform the CIRCUIT OPEN/SHORT INSPECTION .
Specification

Fig 1: Identifying PSP Switch Terminal Continuity
Courtesy of MAZDA MOTORS CORP.
Reconnect the PSP switch connector.