Diagnostic Monitoring Test Results
- The purpose of this test mode is to confirm the result of OBD-II monitor diagnostic test results. The result values which is stored when particular monitor is completed, are displayed. If the monitor is not completed, initial value is displayed.
DIAGNOSTIC MONITORING TEST RESULTS [BP, BP WITH TC]
| TEST ID | Description | Related system |
|---|---|---|
| 10: 01: 11 | HO2S (Front) inversion cycles | HO2S |
| 10: 02: 11 | HO2S (Front) lean-to-rich response time | |
| 10: 03: 11 | HO2S (Front) rich-to-lean response time | |
| 10: 03: 12 | HO2S (Rear) rich-to-lean response time | |
| 10: 04: 01 | HO2S (Front) rich/lean inversion voltage | |
| 10: 04: 02 | Middle/HO2S (Rear) rich/lean inversion voltage | |
| 10: 05: 01 | HO2S (Front) lean threshold voltage | |
| 10: 05: 02 | HO2S (Rear) lean threshold voltage | |
| 10: 06: 01 | HO2S (Front) rich threshold voltage | |
| 10: 06: 02 | HO2S (Rear) rich threshold voltage | |
| 10: 11: 11 | Front and rear HO2S switching time ratio | TWC |
| 10: 24: 00 | Monitoring current for large leak | EVAP |
| 10: 25: 00 | Current gradient for 0.02 in leak | |
| 10: 26: 00 | Monitoring current for purge flow | |
| 10: 27: 00 | Monitoring current for gross leak | |
| 10: 41: 00 | EGR pressure variation | EGR |
| 10: 31: 00 | Heat radiation ratio | THERMOSTAT |
| 10: 32: 00 | ECT |