Diagnostic Flow Chart

Know and understand the customer concerns.
Check the fluid level and condition.
Verify the concern by operating the vehicle.
Check for non-factory installed items and verify correct installation.
Check the shift linkage adjustments.
Check TSBs and MAZDA TIPS messages for vehicle concerns.
Carry out quick test both KOER and KOEO.
Record all codes.

DIAGNOSTIC FLOW CHART

Diagnostic Flow Chart
1) Did you record any Diagnostic Trouble Codes?	Yes	Repair all hard Diagnostic Trouble Codes. See the DIAGNOSTIC TROUBLE CODE NUMBERS , then this flow chart.
1) Did you record any Diagnostic Trouble Codes?	No	GO to Step 5.
2) Are any continuous test memory codes present?	Yes	Clear codes and carry out drive cycle test.
2) Are any continuous test memory codes present?	No	GO to Step 4.
3) Did the continuous test memory codes reappear?	Yes	Repair all continuous test memory codes. See DIAGNOSTIC TROUBLE CODE NUMBERS , then GO to Step 4.
3) Did the continuous test memory codes reappear?	No	GO to Step 4.
4) Is the concern repaired?	Yes	Carry out the final PCM Quick Test to verify that no Diagnostic Trouble Codes are present. Clear memory codes. Return vehicle to customer.
4) Is the concern repaired?	No	See DIAGNOSIS BY SYMPTOM .
5) Are there any electrical concerns?	Yes	Install the diagnostic tool and carry out output state control test, then GO to Step 6.
5) Are there any electrical concerns?	No	See DIAGNOSIS BY SYMPTOM , then GO to Step 7.
6) Was the transaxle concern corrected when the scan tool was installed?	Yes	See the intermittent fault diagnosis section and use the diagnostic tool to diagnose cause of concern in the processor, vehicle harness or external inputs (sensors or switches).
	No	See DIAGNOSIS BY SYMPTOM , then GO to Step 7.
7) Is the concern repaired?	Yes	Carry out the final quick test to verify that no diagnostic trouble codes are present. Clear memory codes. Return the vehicle to the customer.
7) Is the concern repaired?	No	Get assistance from Technical Hotline.