FixVault
Home › Mazda › 2006 › 6 s, 4D Wagon, Standard › Repair and Diagnosis › Engine Performance › System › On-Board Diagnostic [Engine Control System AJ] › After Repair Procedure

After Repair Procedure

  1. Connect the WDS or equivalent to the DLC-2.
  2. Cycle the ignition switch from OFF to ON.
  3. Record DTC if retrieved.
  4. Erase all diagnostic data using the WDS or equivalent.
    Fig 1: Locating DLC-2 Connector
    G04324291Courtesy of MAZDA MOTORS CORP.
About FixVault