Removal and Installation
- Remove the brake disc shield. See
BRAKE DISC SHIELD
.
- Disconnect the negative battery cable. See
BATTERY DISCONNECT
.
- Disconnect the wheel speed sensor electrical connector.
- Remove the wheel speed sensor harness bolt and unclip the retainers.
- To install, tighten to 8 N-m (0.8 kgf-m, 71 in-lbf).
- Remove the wheel speed sensor bolt and the wheel speed sensor.
- To install, tighten to 12 N-m (1.2 kgf-m, 9 ft-lbf).
NOTE:
- Plug the sensor cavity and thoroughly clean the sensor mounting surface. Apply wheel bearing grease to the mounting surface.
- To install, reverse the removal procedure.