Service Cautions: Reassembly

• Standard values, such as torques and certain adjustments, must be strictly observed in the reassembly of all parts.
• If removed, these parts should be replaced with new ones:
  • Oil seals
  • Gaskets
  • O-rings
  • Lock washers
  • Cotter pins
  • Nylon nuts
  Fig 1: Tightening Nut To Specified Torque

  Courtesy of MAZDA MOTORS CORP.
• Depending on location:
  • Sealant and gaskets, or both, should be applied to specified locations. When sealant is applied, parts should be installed before sealant hardens to prevent leakage.
  • Oil should be applied to the moving components of parts.
  • Specified oil or grease should be applied at the prescribed locations (such as oil seals) before reassembly.

Fig 2: Applying To Specified Sealant Location Area

Courtesy of MAZDA MOTORS CORP.