Fuel Pump Resistor Removal/Installation

Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [L3 WITH TC] .)
Disconnect the negative battery cable.
Remove the air cleaner. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
Disconnect the fuel pump resistor connector.
Remove in the fuel pump resistor.

Fig 1: Identifying Fuel Pump Resistor
Courtesy of MAZDA MOTORS CORP.
Install in the order as shown in the figure.
Tightening torque

7.8-11.8 N.m {80-120 kgf.cm, 70-104 in.lbf}
Connect the fuel pump resistor connector.

Fig 2: Identifying Fuel Pump Resistor
Courtesy of MAZDA MOTORS CORP.