Cruise Control Switch Inspection [L3 With TC]: Notes
WARNING: This page is about a different variant/trim than selected.
- Remove the battery cover.
- Disconnect the negative battery cable.
- Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION .)
- Disconnect the audio control switch connector.
- Inspect for resistance and continuity between cruise control switch terminals A-G using a tester.
- If not as specified, replace the cruise control switch. (See AUDIO CONTROL SWITCH REMOVAL/INSTALLATION .)
RESISTANCE SPECIFICATIONSwitch condition Resistance (ohm) ON/OFF button pressed Continuity CANCEL button pressed 118-122 SET/COAST button pressed 667-693 RES/ACCEL button pressed 2,156-2,244 No button pressed No continuity