DTC Inspection [Advanced Keyless System]

WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to the DLC-2 connector.

Fig 1: Identifying DLC-2 Connector (16-Pin)
Courtesy of MAZDA MOTORS CORP.
After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC)
  - Select the "Toolbox" tab.
  - Select "Self Test".
  - Select "Modules".
  - Select "RKE".
- When using the PDS (Pocket PC)
  - Select "Module Tests".
  - Select "Optional" Tab.
  - Select "RKE".
  - Select "Self Test".
Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
After completion of repairs, clear all DTCs stored in the keyless control module.