Transfer Component Assembly Procedure
NOTE:
- Before applying silicone sealant, completely clean off any old silicone sealant and remove any oil or grease.
- After applying silicone sealant, install the drive gear case within 10 min.
- After connecting the sealing area, leave it for 30 min. or more, then add transfer oil.
- Clean the alignment surface of the front carrier and drive gear case, and lightly apply silicone sealant.
- Assemble the transfer component.
Tightening torque
19-27 N.m {2.0-2.7 kgf.m, 14.1-19.9 ft.lbf}
- Install the oil cooler.
- Tighten the oil cooler installation bolt with a O-ring.
Tightening torque
23.5-29.4 N.m {2.4-2.9 kgf.m, 17.4-21.6 ft.lbf}
- Tighten the drain plug with a new washer.
Tightening torque
39.2-58.8 N.m {4.0-5.9 kgf.m, 29.0-43.3 ft.lbf}