Basic Inspection

BASIC INSPECTION [FS5A-EL]

STEP	INSPECTION		ACTION
1	Perform mechanical system test. (See MECHANICAL SYSTEM TEST ) Is mechanical system okay?	Yes	Go to the next step.
1		No	Repair or replace any defective parts according to inspection result.
2	Turn IG SW to ON. When selector lever is moved, does selector illumination indicate synchronized position to lever location? Also, when other ranges are selected from N or P during idling, does vehicle move within 1-2 seconds?	Yes	Go to the next step.
2		No	Inspect selector lever and TR switch. Repair or replace defective areas. (See SELECTOR LEVER INSPECTION. ) (See TRANSAXLE RANGE (TR) SWITCH INSPECTION ) If selector lever and TR switch are okay, go to the next step.
3	Inspect ATF color and condition. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION ) Are ATF color and odor normal?	Yes	Go to the next step.
3		No	Repair or replace any defective parts according to inspection result. Flush ATX and cooler line as necessary.
4	Perform line pressure test. (See LINE PRESSURE TEST. ) Is line pressure okay?	Yes	Go to the next step.
4		No	Adjust accelerator cable as necessary. Repair or replace any defective parts according to inspection result.
5	Perform stall test. (See STALL TEST. ) Is stall speed okay?	Yes	Go to the next step.
5	Perform stall test. (See STALL TEST. ) Is stall speed okay?	No	Repair or replace any defective parts according to inspection result.
6	Inspect value at the following PCM and TCM PIDs using M-MDS. (See PCM INSPECTION ) (See TCM INSPECTION ) PCM PIDs: APP1 APP2 ECT RPM TP_REL VPWR TCM PIDs: TFT TFTV TR TR_SENS MNL SW DWN SW UP SW THOP TSS OSS VPWR TCM Is PID value okay?	Yes	Perform symptom troubleshooting and follow procedures.
6		No	Repair or replace any defective parts according to inspection result.