FixVault
Home › Mazda › 2007 › B3000 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 57 (Automatic Transmission - Service) › Removal & Installation › Low-Reverse Servo › Installation

Low-Reverse Servo: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 Mazda B4000, 2003 Mazda B3000, 2003 Mazda B2300, 2002 Mazda B4000, and 2002 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean and inspect the low/reverse band servo piston bore and the low/reverse band servo piston and rod.
  2. Install the low/reverse band servo piston and rod assembly (1). See Fig 1 . Install a new low/reverse band servo separator plate cover gasket (2).
  3. Install the low/reverse band servo cover (3). Loosely install the low/reverse band servo piston cover screws. Tighten the servo cover screws in the sequence shown. See Fig 2 .
  4. Lower the vehicle. Connect the negative battery cable. Fill the transmission with appropriate fluid to proper level and check for correct transmission operation. See LUBRICATION  .
Fig 1: Exploded View Of Low/Reverse Band Servo
G00115420Courtesy of FORD MOTOR CO.
Fig 2: Low-Reverse Servo Cover Bolt Tightening Sequence
G00023415Courtesy of FORD MOTOR CO.
About FixVault