Instrument Cluster Configuration
NOTE:
- The odometer data (total traveled distance) in the previous instrument cluster is automatically transferred to a new instrument cluster during the configuration.
- Connect the M-MDS to the DLC-2 (16-pin).
- After set up the M-MDS (including the vehicle recognition), the following can be selected from the M-MDS screen.
Using an IDS (Notebook PC):
- "Module Programming"
Using a PDS (Pocket PC):
- "Programming", "Module Programming"
- Select "Programmable Module Installation"
- Select "HEC" and perform procedures according to directions on the M-MDS screen.
- Retrieve DTCs using the M-MDS and verify that there is no DTC present.
- If any DTC is present, perform applicable DTC inspection. (See DTC TABLE[INSTRUMENT CLUSTER] ).