Basic Inspection

BASIC INSPECTION DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	Measure the battery voltage. Is the battery voltage 10.0-14.0 V?	Yes	Go to the next step.
1		No	Replace or recharge the battery. (See BATTERY RECHARGING[L3 WITH TC] ).
2	Inspect the TCM related harnesses, connectors and fuses. Are they normal?	Yes	Go to the next step.
2		No	Repair or replace any malfunctioning parts according to the inspection result.
3	Warm up the engine to normal operating temperature. Retrieve DTC using the M-MDS. Is there any DTC present?	Yes	Record Freeze Frame Data and perform appropriate DTC troubleshooting procedures.
3		No	Go to the next step.
4	Perform the road test. Is the ATX operating normally?	Yes	Go to the next step.
4	Perform the road test. Is the ATX operating normally?	No	Repair or replace any malfunctioning parts according to the inspection result.
5	Perform the time lag test. Is the ATX operating normally?	Yes	Go to the next step.
5	Perform the time lag test. Is the ATX operating normally?	No	Repair or replace any malfunctioning parts according to the inspection result.
6	Perform the stall test. Is the stall speed within the specified?	Yes	Go to the next step.
6		No	Repair or replace any malfunctioning parts according to the inspection result.
7	Perform the line pressure test. Is the line pressure within the specified?	Yes	Perform the symptom troubleshooting and follow the procedures.
7		No	Repair or replace any malfunctioning parts according to the inspection result.
8	Inspect following part or signal related PIDs using the M-MDS. APP sensor TSS VSS TFT sensor TR switch M range switch Up switch Down switch Brake switch Engine speed Are they normal?	Yes	Perform the symptom troubleshooting and follow the procedures.
8		No	Repair or replace any malfunctioning parts according to the inspection result.