FixVault
Home › Mazda › 2007 › CX-9 Sport, 3.5 C, AWD › Repair and Diagnosis › Body & Frame › Door Locks › Security System And Locks System › Request Switch Removal/Installation [Advanced Keyless System] › Liftgate

Request Switch Removal/Installation [Advanced Keyless System]: Liftgate

  1. Disconnect the negative battery cable.
  2. Remove the liftgate upper trim. (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION .)
  3. Remove the liftgate side trim. (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION .)
  4. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION .)
  5. Remove the rear finisher. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION .)
  6. Press the tabs and remove the request switch.
  7. Install in the reverse order of removal.
    Fig 1: Identifying Request Switch And Rear Finisher (Liftgate)
    G04971326Courtesy of MAZDA MOTORS CORP.
About FixVault