FixVault
Home › Mazda › 2007 › CX-9 Touring, 3.5 C, FWD › Repair and Diagnosis › Brakes › Traction Control › Dynamic Stability Control System/Roll Stability Control System › DSC/RSC HU/Cm Removal/Installation › DSC/RSC HU/CM Connector Installation Note

DSC/RSC HU/CM Connector Installation Note

  1. Install the DSC/RSC HU/CM connector using the following procedure:
    1. After verifying that the lock lever is locked by the lower tab, connect the DSC/RSC HU/CM connector to the DSC/RSC HU/CM.
    2. Pull up the lock lever by pressing the lower tab, and release the lock.
    3. Pull up the lock lever and lock it using the upper tab.
  2. Verify that the DSC/RSC HU/CM connector is installed securely.
    Fig 1: Pulling Up Lock Lever
    G04970212Courtesy of MAZDA MOTORS CORP.
About FixVault