FixVault
Home › Mazda › 2007 › CX-9 Touring, 3.5 C, FWD › Repair and Diagnosis › Engine Performance › System › On-Board Diagnostic [Engine Control System MZI-3.5) › DTC P1000 › Notes

DTC P1000: Notes

DTC P1000 (MZI-3.5) DETECTION CONDITION AND POSSIBLE CAUSES

DTC P1000 OBD-II systems readiness test not complete
DETECTION CONDITION 
  • P1000 indicates that the OBD-II monitor testing is not complete.
POSSIBLE CAUSE 
  • The vehicle is new from the factory and has not yet completed an OBD-II Drive Cycle.
  • The battery or the PCM has been disconnected.
  • OBD-II monitor malfunction had occurred before completion of an OBD-II Drive Cycle.
  • The PCM DTCs have been cleared with an M-MDS tester as part of a service process.
About FixVault