FixVault
Home › Mazda › 2007 › CX-9 Touring, 3.5 C, FWD › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle Shift Mechanism › Selector Lever Component Removal/Installation › Selector Cable Installation Note

Selector Cable Installation Note

  1. Install the selector cable and clip to the bracket as shown in the figure.
    NOTE:
    • Steps 2 and 3 are for the selector cable replacement only.
  2. Verify that the selector lever is in the P position.
    Fig 1: Identifying Selector Cable And Cable Bracket
    G04970426
  3. Lock the lock piece of the selector cable (selector lever side) in the order shown in the figure.
    Fig 2: Locking Lock Piece Of Selector Cable
    G04970422
  4. Verify that the manual shaft is in the P position.
    CAUTION:
    • Bending the selector cable in the manner shown in the figure will damage the cable and it may become loose when shifted. When installing the selector cable, hold it straight.
    Fig 3: Inspecting Manual Shaft Joint
    G04970428
  5. Install the clip as shown in the figure.
    Fig 4: Identifying Clip
    G04970429
    NOTE:
    • Install the selector lever to the manual shaft lever with the clip side of the selector cable end facing up.
  6. Install the selector lever to the manual shaft lever so that no load acts on the selector cable.
  7. Confirm that the tip of the manual shaft lever projects out of the end of the selector cable.
  8. Securely install the selector cable to the selector cable bracket.
    Fig 5: Installing Selector Lever To Manual Shaft Lever
    G04970430
About FixVault