Keyless Control Module Removal/Installation

WARNING: This page is about a different car, the 2008 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.

When replacing the keyless control module, perform the following procedure:
- KEYLESS CONTROL MODULE CONFIGURATION (See KEYLESS CONTROL MODULE CONFIGURATION .)
Disconnect the negative battery cable.
Remove the front side trim. (see FRONT SIDE TRIM REMOVAL/INSTALLATION .)
Remove the nut and screw.
Remove the connector clip installed to the bracket by shifting the keyless control module downward.
Disconnect the keyless control module connector.

Fig 1: Identifying Keyless Control Module Remove/Install Components
Courtesy of MAZDA MOTORS CORP.
Push the stopper with a small screwdriver and remove the bracket in the direction shown by the arrow.
Install in the reverse order of removal.

Fig 2: Removing Bracket

Courtesy of MAZDA MOTORS CORP.