FixVault
Home › Mazda › 2009 › 5 Touring, 2.3 3 › Repair and Diagnosis › External Pages › Different car › Section 584 (Entertainment System) › Accessory Socket Removal/Installation › Notes

Accessory Socket Removal/Installation: Notes

WARNING: This page is about a different car, the 2008 Mazda 5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Rear package tray lid (See REAR PACKAGE TRAY LID REMOVAL/INSTALLATION .)
    2. Third-row seat (See THIRD-ROW SEAT REMOVAL/INSTALLATION .)
    3. Rear scuff plate (See REAR SCUFF PLATE REMOVAL/INSTALLATION .)
    4. Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
    5. Lower anchor of the third-row seat belt (See THIRD-ROW SEAT BELT REMOVAL/INSTALLATION .)
    6. Cargo compartment light (See CARGO COMPARTMENT LIGHT REMOVAL/INSTALLATION .)
    7. Trunk side trim (See TRUNK SIDE TRIM REMOVAL/INSTALLATION .)
  3. Remove in the order indicated in the table.
    Fig 1: Identifying Accessory Socket And Cap
    G05543597Courtesy of MAZDA MOTORS CORP.
  4. Install in the reverse order of removal.
About FixVault