Selector Cable Installation Note

Install the selector cable (selector lever component side) to the selector lever securely.
Install the selector cable (selector lever component side) to the selector lever bolt, and then temporarily tighten the nut.
Verify that the selector lever bolt end is exposed from the nut.
Verify that the selector lever is in the P position.
Verify that the manual shaft is in the P position.
CAUTION:
- Bending the selector cable in the manner shown in the figure will damage the cable and it may become loose when shifted. When installing the selector cable, hold it straight.
  
  Fig 1: Identifying Selector Cable, Bolt And Nut
  
  Fig 2: Identifying Bend Position Of Selector Cable
Install the selector cable (transaxle side) to the selector cable bracket securely.

Fig 3: Locating Selector Cable Bracket
Install the clip as shown in the figure.

Fig 4: Identifying Clip
NOTE:
- Install the selector cable to the manual shaft lever with the clip side of the selector cable end facing the front of the vehicle.
Install the selector cable to the manual shaft lever in such a way that the selector cable does: not bear a load.
Verify that the manual shaft lever end is exposed from the selector cable end.
Install the nut completely so that no load acts on the selector lever.
Tightening torque

10-15 N.m {1.1-1.5 kgf.m, 7.4-11.0 ft.lbf}

Fig 5: View Of Selector Cable And Manual Shaft Lever