FixVault
Home › Mazda › 2009 › 6 i SV, 2.5 A › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System (L5) › Neutral Switch Inspection [L5] › Continuity Inspection

Continuity Inspection

  1. Disconnect the negative battery cable.
  2. Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R] .)
  3. Inspect for continuity between the neutral switch terminals using an ohmmeter.
    • If not as specified, replace the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION [G66M-R] .)
      Fig 1: Identifying Neutral Switch Components & Connector Terminals
      G06205234Courtesy of MAZDA MOTORS CORP.
      SPECIFICATION

      Measured condition Continuity
      Rod pushed Continuity detected
      Except above No continuity
About FixVault