FixVault
Home › Mazda › 2010 › 3 Mazdaspeed, 2.3 4 › Repair and Diagnosis › Body & Frame › Door Locks › Security System And Locks System › Liftgate Opener Switch Inspection

Liftgate Opener Switch Inspection

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Liftgate upper trim (See LIFTGATE UPPER TRIM REMOVAL/INSTALLATION .)
    2. Liftgate side trim (See LIFTGATE SIDE TRIM REMOVAL/INSTALLATION .)
    3. Liftgate lower trim (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION .)
    4. Liftgate latch and lock actuator (See LIFTGATE LATCH AND LOCK ACTUATOR REMOVAL/INSTALLATION .)
    5. Liftgate opener switch (See LIFTGATE OPENER SWITCH REMOVAL/INSTALLATION .)
  3. Verify the continuity of liftgate opener switch terminals A and B.
    Fig 1: Identifying Liftgate Opener Switch Terminals A And B
    G06731994Courtesy of MAZDA MOTORS CORP.
  4. Verify that the continuity is as indicated in the table.
    Fig 2: Continuity Chart
    G06731995Courtesy of MAZDA MOTORS CORP.
    • If not as indicated in the table, replace the liftgate opener switch.
About FixVault