FixVault
Home › Mazda › 2010 › 3 Mazdaspeed, 2.3 4 › Repair and Diagnosis › Body & Frame › Ignition Switch/Steering Lock › Power Systems › Starter Cut Relay Removal/Installation [MTX] › Advanced Keyless Entry And Push Button Start System Only

Advanced Keyless Entry And Push Button Start System Only

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. Side wall (See SIDE WALL REMOVAL/INSTALLATION .)
    4. Console (See CONSOLE REMOVAL/INSTALLATION .)
  3. Set the hood release lever out of the way. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
  4. Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION .)
  5. Disconnect the connector.
    Fig 1: Identifying Starter Cut Relay And Connector
    G06733190Courtesy of MAZDA MOTORS CORP.
  6. Remove the nut.
  7. Remove the starter cut relay.
  8. Install in the reverse order of removal.
    Fig 2: Starter Cut Relay With Torque Specifications
    G06733191Courtesy of MAZDA MOTORS CORP.
About FixVault