Selector Cable Installation Note

Install the selector cable (selector lever component side) to the selector lever securely.
Install the selector cable (selector lever component side) to the selector lever bolt, and then temporarily tighten the nut.
Verify that the selector lever bolt end is exposed from the nut.
Verify that the selector lever is in the P position.
Verify that the manual shaft is in the P position.
CAUTION:
- Bending the selector cable in the manner shown in the illustration will damage the cable and it may become loose when shifted. When installing the selector cable, hold it straight.
  
  Fig 1: Identifying Selector Cable, Bolt And Nut
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 2: Identifying Bend Position Of Selector Cable
  Courtesy of MAZDA MOTORS CORP.
Install the selector cable (transaxle side) to the selector cable bracket securely.

Fig 3: Locating Selector Cable Bracket
Courtesy of MAZDA MOTORS CORP.
Install the clip as shown in the illustration.

Fig 4: Identifying Clip
Courtesy of MAZDA MOTORS CORP.
NOTE:
- Install the selector cable to the manual shaft lever with the clip side of the selector cable end facing the front of the vehicle.
  
  Fig 5: Installing Selector Cable To Manual Shaft Lever
  Courtesy of MAZDA MOTORS CORP.
Install the selector cable to the manual shaft lever in such a way that the selector cable does not bear a load.
Verify that the manual shaft lever end is exposed from the selector cable end.
Install the nut completely so that no load acts on the selector lever.
Tightening torque

10-15 N.m {1.1-1.5 kgf.m, 7.4-11.0 ft.lbf}