Barometric Pressure (BARO) Sensor Inspection
CAUTION:
- The BARO sensor cannot be removed as a single unit. When replacing the BARO sensor, replace it together with the PCM as a single unit.
- Connect the M-MDS to the DLC-2.
- Switch the ignition to ON.
- Verify that the BARO sensor output voltage (M-MDS PID: BARO) is within the specification. (See
PCM INSPECTION .)
- If not as specified, replace the PCM.
(See PCM REMOVAL/INSTALLATION .)
- If not as specified, replace the PCM.