FixVault
Home › Mazda › 2011 › 3 Mazdaspeed, 2.3 3 › Repair and Diagnosis › External Pages › Different car › Section 652 (Security System And Locks System) › Trunk Key Cylinder Removal/Installation

Trunk Key Cylinder Removal/Installation

WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the trunk end trim. (See TRUNK END TRIM REMOVAL/INSTALLATION .)
  3. Detach the rod.
  4. Remove the nuts, then remove the trunk key cylinder.
  5. Install in the reverse order of removal.
Fig 1: Trunk Key Cylinder Switch Connector, Trunk Key Cylinder And Nut With Torque Specifications
G04928931Courtesy of MAZDA MOTORS CORP.
About FixVault