FixVault
Home › Mazda › 2011 › 3 Mazdaspeed, 2.3 4 › Repair and Diagnosis › External Pages › Different car › Section 652 (Security System And Locks System) › Keyless Receiver Removal/Installation [With Keyless Entry System]

Keyless Receiver Removal/Installation [With Keyless Entry System]

WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Speaker grille (See SPEAKER GRILLE REMOVAL/INSTALLATION .)
    2. Center speaker (See CENTER SPEAKER REMOVAL/INSTALLATION .)
    3. Center panel unit (See CENTER PANEL UNIT REMOVAL/INSTALLATION .)
    4. Center panel (See CENTER PANEL REMOVAL/INSTALLATION .)
  3. Remove the nuts.
  4. Disconnect the keyless receiver connector.
  5. Install in the reverse order of removal.
Fig 1: Keyless Receiver Connector And Nut With Torque Specifications
G05986007Courtesy of MAZDA MOTORS CORP.
About FixVault