FixVault
Home › Mazda › 2011 › 3 Mazdaspeed, 2.3 4 › Repair and Diagnosis › External Pages › Different car › Section 667 (Lighting System) › Flasher Control Module Removal/Installation

Flasher Control Module Removal/Installation

WARNING: This page is about a different car, the 2011 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Disconnect the connector.
  3. Remove the screw and then remove the flasher control module.
  4. Install in the reverse order of removal.
Fig 1: Identifying Flasher Control Module, Connector And Screw
G05986224Courtesy of MAZDA MOTORS CORP.
About FixVault