Neutral Switch Inspection
WARNING: This page is about a different variant/trim than selected.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [LF, L5] ).
- Disconnect the negative battery cable.
- Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION ). (See NEUTRAL SWITCH REMOVAL/INSTALLATION ). (See NEUTRAL SWITCH REMOVAL/INSTALLATION ).
- Inspect for continuity between the neutral switch terminals using an ohmmeter.
- If not as specified, replace the neutral switch. (See
NEUTRAL SWITCH REMOVAL/INSTALLATION
). (See
NEUTRAL SWITCH REMOVAL/INSTALLATION
). (See
NEUTRAL SWITCH REMOVAL/INSTALLATION
).SPECIFICATION
Measured condition Continuity Rod pushed Continuity detected Except above No continuity
- If not as specified, replace the neutral switch. (See
NEUTRAL SWITCH REMOVAL/INSTALLATION
). (See
NEUTRAL SWITCH REMOVAL/INSTALLATION
). (See
NEUTRAL SWITCH REMOVAL/INSTALLATION
).