FixVault
Home › Mazda › 2011 › 3 i SV, 2.0 F › Repair and Diagnosis › Engine Performance › System › On-Board Diagnostic [Engine Control System LF, L5] › DTC P0602:00

DTC P0602:00

DTC P0602:00  PCM programming error 
DETECTION CONDITION 
  • No configuration data in the PCM.
    NOTE:
    • If the "PCM CONFIGURATION" is successful, the PCM stores the DTC P0602:00 and illuminates the MIL (system is normal). Clear the DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION".
    • The MIL goes out after three drive cycles with no failure (The DTCs remain in the PCM).

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • PCM configuration has not been completed
  • PCM malfunction
DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA HAS BEEN RECORDED 
  • Has the FREEZE FRAME DATA (Mode 2)/snapshot data been recorded?
 Yes Go to the next step.
No Record the FREEZE FRAME DATA (Mode 2)/snapshot data on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 PERFORM PCM CONFIGURATION 
 Yes Perform the PCM configuration again, then go to the next step.
(See PCM CONFIGURATION ).
No Go to Step 5.
4 VERIFY DTC TROUBLESHOOTING COMPLETED 
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No DTC troubleshooting completed.
About FixVault