FixVault

DTC P2119:00

DTC P2119:00  Throttle valve actuator control throttle body range/performance problem 
DETECTION CONDITION 
  • The PCM compares the TP with the default TP when switch the ignition to off. If the TP is higher than the default TP, the PCM determines that there is a throttle valve actuator control throttle body range/performance problem.

Diagnostic support note 
  • This is a continuous monitor (CCM).
  • The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
  • FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
  • The DTC is stored in the PCM memory.
POSSIBLE CAUSE 
  • Throttle valve malfunction
  • Throttle valve actuator malfunction
  • PCM malfunction
DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA (MODE 2)/SNAPSHOT DATA HAS BEEN RECORDED 
  • Has the FREEZE FRAME DATA (Mode 2)/snapshot data been recorded?
Yes Go to the next step.
No Record the FREEZE FRAME DATA (Mode 2)/snapshot data on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Verify related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT THROTTLE VALVE ACTUATOR 
  • Switch the ignition to off.
  • Inspect the throttle valve and throttle valve actuator.

    (See THROTTLE BODY INSPECTION ).

  • Is there any malfunction?
Yes Replace the throttle body, then go to the next step.
(See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION ).
No Go to the next step.
4 VERIFY DTC TROUBLESHOOTING COMPLETED 
Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE 
Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No DTC troubleshooting completed.