NOT P Position Switch Inspection

CAUTION:

• Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

1. Disconnect the selector lever component connector.
   1. Disconnect the negative battery cable.
   2. Remove the rear console. (See REAR CONSOLE REMOVAL/INSTALLATION .)
   3. Disconnect the selector lever component connector.
   Fig 1: Selector Lever Component Connector

   Courtesy of MAZDA MOTORS CORP.
2. Measure the continuity between selector lever component terminals G and K.

• If there is any malfunction, replace the selector lever component. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION .)

SWITCH SPECIFICATION CHART

Test condition	Continuity
P position	No continuity
Except P position	Continuity

Fig 2: Selector Lever Component Connector Terminals

Courtesy of MAZDA MOTORS CORP.