FixVault
Home › Mazda › 2011 › CX-7 i SV, 2.5 5 › Repair and Diagnosis › Accessories & Equipment › Communication Devices › Control System (Body Control Module) › Body Control Module (BCM) Inspection › Notes

Body Control Module (BCM) Inspection: Notes

  1. Disconnect the negative battery cable.
  2. Remove the following parts:
    1. Front scuff plate, (driver-side) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Front side trim, (driver-side) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. Console panel. (See CONSOLE PANEL REMOVAL/INSTALLATION .)
    4. Console (See CONSOLE REMOVAL/INSTALLATION .)
  3. Set the hood release lever out of the way. (See HOOD LATCH AND RELEASE LEVER REMOVAL/INSTALLATION .)
  4. Remove the lower panel. (See LOWER PANEL REMOVAL/INSTALLATION .)
  5. Remove the BCM with the connector connected. (See BODY CONTROL MODULE (BCM) REMOVAL/INSTALLATION .)
  6. Connect the negative battery cable.
  7. Measure the voltage at each terminal is as indicated in the Terminal Voltage Tables below.
    • If the voltage is not as specified in the Terminal Voltage Table, inspect the parts under "Inspection item (s)".
      • If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the BCM.
About FixVault