| 2 |
PERFORM ADDITIONAL KEY PROGRAMMING
- Connect the M-MDS to the DLC-2.
(See
M-MDS CONNECTING PROCEDURE .)
- Insert key 1 into the key slot and depress the brake pedal.
NOTE:
- The keyless indicator light (green) illuminates for approx. 5 s and then turns off.
- Within 5 s after verifying that the keyless indicator light (green) illuminates, release the brake pedal and turn the ignition switch to the LOCK→ACC→ON.
- Remove key 1 from the key slot and insert key 2 into the key slot.
NOTE:
- After key 1 is removed, continue to perform the procedure as indicated even though the advanced key system warning alarm sounds and the keyless indicator light (red) starts to flash.
- After vehicle identification, select the following from the M-MDS initial screen.
- Using an IDS (laptop PC):
- Select "Body".
- Select "Security".
- Select "PATS Functions".
- Using a PDS (pocket PC):
- Select "All Tests and Calibrations".
- Select "PATS Functions".
- Then, select the following from the screen menu.
Item
- "Program Additional Ignition Key"
- Perform the security access according to the directions on the M-MDS screen.
NOTE:
- After executing the above menu, "This operation is successful" is displayed. At this stage, the programming for the key switching the ignition ON is completed.
- If an additional key is to be programmed, continue to perform the procedure according to the directions on the M-MDS screen. To finish the key programming, go to the next step.
|
Yes |
Change the key and repeat Step 2. |