FixVault
Home › Mazda › 2011 › CX-9 Touring, 3.7 A, AWD › Repair and Diagnosis › Brakes › Traction Control › Dynamic Stability Control System/Roll Stability Control System › DSC/RSC HU/Cm Removal/Installation › DSC/RSC HU/CM Connector Removal Note

DSC/RSC HU/CM Connector Removal Note

  1. Remove the DSC/RSC HU/CM connector using the following procedure:
    1. Press down the lock lever while pressing the upper tab to release the lock.
    2. Press down the lock lever and lock it using the lower tab.
    3. Remove the DSC/RSC HU/CM connector by pulling it in the direction of the arrow as shown in illustration.
      Fig 1: Removing DSC/RSC HU/CM Connector
      G04970208Courtesy of MAZDA MOTORS CORP.
About FixVault