FixVault
Home › Mazda › 2011 › RX-8 R3, 1.3 2 › Repair and Diagnosis › Body & Frame › Door Locks › Security System And Locks System › Request Switch Removal/Installation [With Advanced Keyless System] › Trunk Lid

Trunk Lid

  1. Disconnect the negative battery cable.
  2. Remove the rear bumper. (Refer to the REAR BUMPER REMOVAL/INSTALLATION in appropriate Body Panels article .)
  3. Detach the request switch from the rear bumper.
  4. Install in the reverse order of removal.
Fig 1: Identifying Request Switch, Connector And Rear Bumper
G04928916Courtesy of MAZDA MOTORS CORP.
About FixVault