DTC P0602:00: Notes

DTC P0602:00	PCM programming error
DETECTION CONDITION	No configuration data in the PCM. NOTE: If the "PCM CONFIGURATION" is successful, the PCM stores the DTC P0602:00 and illuminates the MIL (the system is normal). Clear the DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION". The MIL turns off after three drive cycles with no failure (the DTCs remain in PCM). Diagnostic support note This is a continuous monitor (CCM). The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle. FREEZE FRAME DATA (Mode 2)/Snapshot data is available. The DTC is stored in the PCM memory.
POSSIBLE CAUSE	Configuration procedure has not been completed PCM malfunction

DTC P0602:00

PCM programming error

DETECTION CONDITION

NOTE:

If the "PCM CONFIGURATION" is successful, the PCM stores the DTC P0602:00 and illuminates the MIL (the system is normal). Clear the DTC P0602:00 using the M-MDS after the "PCM CONFIGURATION".
The MIL turns off after three drive cycles with no failure (the DTCs remain in PCM).
Diagnostic support note
This is a continuous monitor (CCM).
The MIL illuminates if the PCM detects the above malfunction condition during the first drive cycle.
FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
The DTC is stored in the PCM memory.

POSSIBLE CAUSE