For Right Bank

1. Disconnect OCV (RH) connector.
2. Warm up the engine and it at idle.
3. Apply the battery voltage to the OCV and verify that the engine idles roughly or stalls.
   • If the engine idles roughly or stalls, inspect the timing belt component (valve timing deviation).
   • If the engine does not idle roughly or stall, go to the next step.
4. Remove the OCV (RH) and perform the spool valve operation inspection. (See OIL CONTROL VALVE (OCV) REMOVAL/INSTALLATION .)
   • If not as specified, inspect the following:
     • OCV (RH) (See OIL CONTROL VALVE (OCV) INSPECTION .)
     • Harnesses and connectors between OCV (RH) and PCM have an open or short circuit.
   • If as specified, inspect the following right bank hydraulic passages for clogging or leakage, or both.
     • Oil pressure switch-OCV
     • OCV-Camshaft
     • Camshaft internal passage
5. If they are normal, replace the right bank camshaft pulley (with built-in variable valve timing actuator).

When idling can be continued