Spark Test

Disconnect the fuel pump relay.
Verify that each ignition coil and connector is connected properly.
Inspect the ignition system in the following procedure.
WARNING:
- High voltage in the ignition system can cause strong electrical shock which can result in serious injury. Avoid direct contact to the vehicle body during the following spark test.

STEP	INSPECTION		ACTION
1	Disconnect the ignition coil from the spark plugs. Remove the spark plugs. (See SPARK PLUG REMOVAL/INSTALLATION .) Verify that the spark plugs do not have carbon deposits. Is there any malfunction?	Yes	Perform no-load racing at 4,000 rpm for 2 min , 2 times to burn off the carbon deposits. Repeat Step 1.
1		No	Go to the next step.
2	Inspect the spark plugs for damage, wear, and proper plug gap. Is there any malfunction?	Yes	Replace spark plugs, then go to Step 1. (See SPARK PLUG REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	Reconnect the spark plugs to the ignition coil. Ground the spark plugs to the engine. Is a strong blue spark visible at each cylinder while cranking the engine?	Yes	Ignition system is normal.
3		No	Some cylinders do not spark: Go to the next step. All cylinders do not spark: Go to Step 5.
4	Inspect for open or short circuit between the following terminals (wiring harness-side): Ignition coil No.1 terminal C-PCM terminal 2G Ignition coil No.2 terminal C-PCM terminal 2K Ignition coil No.3 terminal C-PCM terminal 2L Ignition coil No.4 terminal C-PCM terminal 2H Is there any malfunction?	Yes	Repair or replace the suspected wiring harness, then go to Step 1.
4		No	Inspect and replace the ignition coil, then go to Step 1. (See IGNITION COIL INSPECTION .) (See IGNITION COIL REMOVAL/INSTALLATION .)
5	Turn the ignition switch to the ON position (engine off). Measure the voltage at the terminal A (wiring harness-side) in each ignition coils. Is the voltage B+ ?	Yes	Go to the next step.
5		No	Inspect the power supply circuit of ignition coils. Repair or replace the suspected wiring harness, then go to Step 1.
6	Inspect the PCM and ignition coil connector or terminals for poor connection. Is there any malfunction?	Yes	Repair or replace the malfunctioning connector or terminals, then go to Step 1.
6		No	Go to the next step.
7	Inspect the CKP sensor and crankshaft pulley. (See CRANKSHAFT POSITION (CKP) SENSOR INSPECTION .) Is there any malfunction?	Yes	Repair or replace the malfunctioning part according to the inspection results, then go to Step 1.
7		No	Inspect for open or short circuit in wiring harness and connector of CKP sensor. Repair or replace the malfunctioning part according to the inspection results, then go to Step 1.