FixVault
Home › Mazda › 2013 › CX-5 Sport, FWD, Automatic Trans › Repair and Diagnosis › Body & Frame › Exterior/Interior Trim › Interior Trim › Switch Panel Removal/Installation

Switch Panel Removal/Installation

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0] ).
  2. Remove the car-navigation unit, (with car-navigation system) (See CAR-NAVIGATION UNIT REMOVAL/INSTALLATION ).
  3. Insert your hand from the lower side of the lower panel (without car-navigation system) or the area where the car-navigation unit was installed (with car-navigation system), press the switch panel in the direction of the arrow (1) shown in the figure and remove it while detaching hook A and B and hook C.
    Fig 1: Removing Car-Navigation Unit
    G09077212
  4. Disconnect the cluster switch connector.
  5. Remove the cluster switch in the direction of the arrow (3) while detaching hooks D in the direction of the arrow (2).
    Fig 2: Removing Cluster Switch
    G09077213
  6. Install in the reverse order of removal.
About FixVault