DTC P011A-00: ECT Sensor No.1/No.2 Performance Problem: Notes

DETECTION CONDITION AND POSSIBLE CAUSE

DTC P011A:00	ECT sensor No.1/No.2 performance problem
DETECTION CONDITION	When the ECT sensor No.2 detected temperature is approx. 20.0°C {68.0°F} higher than the ECT sensor No.1, or the ECT sensor No.2 detected temperature is approx. -47.6°C {-53.7°F} less than the ECT sensor No.1 with the ignition switch is ON, the PCM detects a circuit/range performance problem. : Ignition switch is ON when 6 h or more have passed since the ignition was switched to off. Diagnostic support note This is a continuous monitor (engine cooling system). The check engine light illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM. PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle. FREEZE FRAME DATA (Mode 2)/Snapshot data is available. The DTC is stored in the PCM memory.
FAIL-SAFE FUNCTION	-
POSSIBLE CAUSE	ECT sensor No.1 connector or terminals malfunction ECT sensor No.2 connector or terminals malfunction PCM connector or terminals malfunction ECT sensor No.1 malfunction ECT sensor No.2 malfunction PCM malfunction
SYSTEM WIRING DIAGRAM	-